Stylish Landroid Wheels

After about 4 years in my rough garden, it was time to replace my previous wheels (thing:3750909). This time I did not care about material saving, print time or anything like that, I just wanted to make some nice looking wheels!

From my previous design, I extracted the studs and then made a new design based on common aluminum wheels for cars. When it was done, I also made a cap to cover the nut holding the wheel.

Tested on Worx Landroid WG709e and on WG790e.1. It can probably be adopted to other mowers as well without any big issues.

The cap snaps in place, but has a tight fit and brittle tabs so take it easy when mounting them. I added some slots to fit a screw driver when they need to come off.