Prop Spinners: 2x2-CW&CCW| 3x3-CW&CCW (Standard)| 3x3-CW&CCW (Wide Chord)| Base: 5mm, 6mm, 7mm Shaft for any Spinner

Prop Spinners for a variety of applications. Pusher Props, Twin Props, etc. File Downloads are available for two and 3 bladed props, with an addition of wide chord 3 blade prop spinners for brands such as master airscrew. The spinners should be printed with 10-15% infill, .12-.20 layer height, 2 walls and 2-3 top and bottom solid layers. Test prints were done using PETG, but can be printed in PLA, ABS, Nylon, or PETG. I have done fit tests only on Gemfan, APC, Master Airscrew, and GepRC props ranging from 6"-11" diameter. I have not subjected the spinners to RPM tests, but have had luck with similar spinners on high KV, 4S Motor and Battery Setups. It is recommended to use supports on the wide spinner base, as the center is recessed to allow for more thread engagement when tightening the nut on the prop.