FALCONSSON - FOLDABLE TRIPOD MONOPOD

Falconsson designs & social media: https://linktr.ee/falconsson

License: PRIVATE USE

Subscribe to my patreon for commercial rights: https://patreon.com/falconsson

http://falconsson.com

https://www.youtube.com/@falconssonGe

Hi there!

• The tripod has an adjustable tilt head and is compatible with the standard 1/4-inch camera

mount.

• In its folded state, it occupies minimal space and is easy to carry. It can also be used as a

monopod.

• This was my first design, and it has now been completely revised. The overhangs have

been cleared and the tolerances have been fine-tuned. It can be printed in less than two

hours with around 50 grams of filament. It doesn't require supports or additional hardware

to print.

• For screw tolerances to work right, it must be printed with dimensionally accurate filament.

PLA, PLA+, PETG, and HIGH SPEED PETG are recommended.

• To increase rigidity, the hinge screw can be replaced with a 45 mm M5 bolt, and the

plastic camera mount can be replaced with a standard 1/4-inch metal one, though this is

not essential.

May the perfect first layer be with you!

See you on the next design!