Ender-3 V3 KE/SE removable bin, cable holder and lid

English

Use it as a trash bin for the first extrusion line and extruded filament after a change, or as a storage container for tools.

After printing, test if it fits easily. Depending on your print quality, it may be necessary to grind down the corners of the pin that goes into the holder so that it slides in and out easily without force; otherwise, it is hard to remove the bin.

*I used a PEI build plate for the surface of the lid*

See also my right bin with nebula mount - https://m.crealitycloud.com/en/model-details/65da4fc596ef231d8fc514ad

Attention: Please measure the width of the frame. The width must be 40mm. Apparently there are deviations in the width of some printers! If the width is correct (approx. 40mm) then the holder sits securely and firmly.

----------------------------------------

German

Use it as a trash bin for the first extrusion line and extruded filament after a change, or as a storage container for tools.

After printing, test if it fits easily. Depending on your print quality, it may be necessary to grind down the corners of the pin that goes into the holder so that it slides in and out easily without force; otherwise, it is hard to remove the bin.

*I used a PEI build plate for the surface of the lid*

See also my right bin with camera mount - https://m.crealitycloud.com/en/model-details/65da4fc596ef231d8fc514ad

Attention: Please measure the width of the frame. The width must be 40mm. Apparently there are deviations in the width of some printers! If the width is correct (approx. 40mm) then the holder sits securely and firmly.