Calibration Fidget Toy - Square Pushpin Board

Test your printer's accuracy with these fun fidget toys! A whole board of pushpins, good for stress release at the desk.

Update 01/12/2025

Newly updated designs have been improved for easier printing! Overhang angles have been adjusted to help prevent the pins from getting stuck.

You may want to check out our new Deluxe Sets with even more shapes and sizes:

Push-Pin Fidget Grids 

XL Push-Pin Fidget Grids 

0.3mm clearance between all the circular edges. Pins will require a satisfying popping out once after a fresh print. If the bottom fuses together, your z-offset may be too low. If you see any over-extruding or stringing, you nozzle temp is likely too high and should be lowered. Can be a bit of a tricky print, but super satisfying once finished.

Printed on an Ender-3 V3 SE at 180 mm/s, concentric infill at 20%, with 2-3 line walls. Temperature settings vary between filaments.

If you're a fan of fidget toys, you may also want to check out our Sliding Fidget Cubes Set here:

  Sliding Fidget Cubes Set

Thanks for checking it out! Head over to my page or follow for other useful mods and cool prints.