PRINT IN PLACE - WAFFLE MAKER - FLOWER - FOR SENSORY PLAY

3D MODEL DESCRIPTION

Waffle makers for kiddies for playdough, kinetic sand and any sensory play.

PRINT IN PLACE! NO ASSEMBLY NEEDED! JUST PRINT AND PLAY!

These waffle makers' measurements are reflected in the display image. It will give you some idea of the dimensions.

This is a small design – made for small hands. Please note that if you scale this design bigger, you will have a looser fit at the joints.

At this size, the offset between the moving parts is 0.2mm. That will increase if you scale it larger.

The whole model is chamfered to perfection in and outside for flawless printing.

PRINT SETTINGS

PLEASE READ THE PDF INSTRUCTIONS INCLUDED.

• No less than 3 wall widths of 0.4mm.

• No less than 12% Lines or zig zag infill.

• A strong infill would be Gyroid.

• A 0.2mm layer height is sufficient.

• Slower printing always equals a good quality print (unless you are spoilt with a fast printer!).

• Follow the instructions of the filament producer for heat settings.

• I use PLA for my prints and the longevity and strength is just fine.