Tenlog TL-D3 Pro Z stabilizer

Bill of materials

- 4 units -- Nuts M3

- 4 units -- Screw DIN912 M3x18

You can choose from three types of tubes:

- 2 units -- Aluminium Tube outside diameter 12mm L=525mm (use the stl with name D12)

- 2 units -- Aluminium Tube outside diameter 10mm L=525mm (use the stl with name D10)

- 2 units -- Aluminium Tube outside diameter 1/2" L=525mm (use the stl with name D1_2)

Steps to follow for installation

Remove the original leadscrew and upper Z-axis supports

- Assemble the new top brackets (use the same nuts and screws; for the top cover, you can use the original or print the new one)

- Remove the electronics cover

- Remove the two rear screws on the 4020 profile that fix the bottom support

- Assemble the Z-axis bottom supports

- Assemble the Z-axis rods

- Make sure the Z-axis is perfectly perpendicular to the base

- Tighten all the screws (make sure the Z-axis is perpendicular to the base)

Boost Me

If you liked the design, please support me!

Boost