The Serpent LED MagicRelief Frame - 100 x 150

This snake-themed frame is a striking blend of gothic elegance and modern tech. The way the integrated LEDs interact with the Galaxy filament creates a shifting, ethereal glow that perfectly complements the serpent's scales.

Detailed snakes that coil symmetrically around the border, meeting at a decorative crest.

HueForge Compatible: The center window is optimized for HueForge prints, lithophanes, or standard photos, providing a high-contrast backdrop that makes green and metallic filaments pop.

The use of Matte Black for the inner filigree provides a deep, non-reflective base that allows the shimmering "Galaxy" green snake overlay to stand out.

For the best visual effect, use a 5V COB LED strip. These provide a seamless line of light without the "dot" effect, which makes the translucent properties of the Galaxy filament look like magic. You can also use aRGB for animation, however I did not have any cob aRGB on hand to show the effect.

The frame features a dedicated internal cavity to house the LEDs with a clean look from both the front and sides. DO NOT remove the back tape, it will make the installation very difficult.

Designed for a tight fit, the back has either rings or an entire backplate (printed in red galaxy so there is some glow in the back), allowing you to swap out the center artwork (like the meditating robot shown). I used self tapping screws, 2.5mm x 5mm.

Boost Me

TY

Boost