Batman - Bookmark

Batman Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 47x150mm in size.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked , adjust the Y axis to the desired size (180max for A1 mini and 250max for P1/X1, this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale , adjust the Z axis back to 100% , slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Jade White Transmission Distance: 5 This print uses 3 unique filaments

Swap Instructions: Start with Black At height depth  (1.04mm) swap to Blue Gray At height depth  (1.36mm) swap to Jade White for the rest.

In addition, the bookmark was converted to an Inlay version to be used with cP3D Headset stand and the box at https://makerworld.com/en/models/1103896#profileId-1099415 .