Badge + RSA holder NO SUPPORTS (1-3 cards)

This remixes my original design to make it even easier to print, and thinner (7mm instead of 8mm), at the expense of the ability to see two cards at the same time and the smooth chamfered edges on the back.  This holder can store 1-3 cards depending on their thickness, but with only a single card, it fits a little loosely, where each card fits securely on its own in my original design.  This remix still has room for an additional small card like a store membership or library card, but it and the frame, will block visibility of any inside cards from the back.

The holder requires/relies on the badges own lanyard or clip slot as seen in the photos.

The RSA slot is very snug so that it won't fall out.  To install safely, insert the lanyard ring/nub into the diamond shaped hole in holder and keep the token perpendicular to the holder itself.  Push the opposing end of the token into the holder frame so that the token is in place within the frame, but still perpendicular to its final orientation.  Finally, rotate the token within the frame so it is facing the desired final orientation.  Keep in mind, it is possible to separate/damage the housing of the RSA token if you try too hard to shove the token into the frame without following the above steps.