Bambulab P1 Series Drag chain Cable clip Frontend

Issue: Ptfe tube sits in front of the Dragchain on the printhead.

Solution: Align the Ptfe tube to its Natural position in front of the Drag chain, near the printhead side.

This model of clips, does exactly that. Before you go off printing these the following Models below are Highly recommended.

ONLY use 1-3 of these clips closer to the Printhead area.

I Highly  recommended to use my clips with the PTFE tube guide's here :  (These tend to break if you remove them too many times, I designed a Beefier one, but its also harder to remove.

PTFE Tube Guide by 3DTechBase - MakerWorld

or

Extra strength P1S Toolhead PTFE TUBE GUIDE by Ryxxi_makes MakerWorld: Download Free 3D Models

and Print the Other clips from this model here: Edit Model - MakerWorld

Thse clips go on the ffront end of the Drag chain/cable chain. CLose to where the  Printhead is. These clips will help align the ptffe tube better with the hotend.

Boost Me