Minecraft Lever for single/dual Flat Light Switch

Update: (See original description below) I was able to remix this into a double lever for flat switches.  I also cleaned up the models and fixed some painting issues.  The plates include parts to print both a single and a double.  You will only need a single lever, handle, internals (gear, pin, clip, block) if you print the single light switch.  You can just move the others off the plate or delete them as they are just copies.  I was able to print the double switch cover without a purge tower and it came out looking great and is the one you see in the photos (your results may vary).

NOTE: If you have trouble when installing the levers, it might be due to the blocks not fitting all the way in.  The printing supports seem to always leave a tiny ridge that prevents the squeeze fit of the blocks into the gear track.  If this does not sit all the way in, the light switches get too much pressure put on them.  You will also need longer #6-32 screws to hold the plate on the wall.  They just need to be a little longer so don't go too long.

I reorganized the parts to fit on the A1 mini plates.  I colored the squares on the switch plate and handle to print with the AMS lite.  I made the handle bigger because I wanted to add more color to it.  I increased the size of the connection to the gear to give the new handle more surface area for glue.  The lever has good resistance on it once installed so the added weight of the bigger lever was not an issue.