Leg for Monitor Riser

Leg for a monitor riser / desk shelf. Height of leg is 13cm. Leg is symmetrical - same model for left and right side. To be mounted by 6mm countersunk screws. I used metric screws an threaded inserts in the wood board. Desk shelf supported by 2 legs printed from PLA with attached profile (25% infill, 4 walls, 0.2mm layer) will hold 85kg (tested by me sitting on it :). Probably it will do just fine with less infill / walls but I wanted to be sure it won't fail. To be printed on side. I wanted both sides to be smooth - printed on Cool Plate SuperTack. Based on my experience, matt PLA does not hold as good on this plate as good as ordinary PLA. I had some problems with lifting in corners which came after half of the print, so I slowed down the print and added brim to help solve it.

Optional anti-slip/vibration feet are printed from TPU and I glued them to the bottom of legs with contact glue.