Nintendo Switch 1 / 2 Game Cartridge Holder 16 + 4

**Important** The print will pause at layer 30. This is where you put in the four 7x2mm magnets. Ensure the magents are aligned appropriately before resuming printing.

These Nintendo Switch cartridge holders will hold 16 game cartridges and 4 micro SD cards.

When closed, the case is only 1cm thick. The general dimensions are 137mm x 89mm.

The two sides hold together with four 7x2mm magnets which are inserted mid print into four corners of the design. The magnets are then covered with the remaining two top layers of the case.

I've uploaded two profiles for printing the insert, TPU and PLA. I think TPU is better for gripping the cartridges. A bit of glue between the insert and the shell hold it perfectly.

Need a NSW2 grip case? Check this out:

https://makerworld.com/en/models/1495761

or a NSW2 Pro Controller Stand:

https://makerworld.com/en/models/1538106

The shells currently have the following themed designs:

- Pokedex - Sheikah Slate - Triforce - Nintendo Console Logos - Nintendo Switch Logo - Super Mario - Pokemon Legends Z-A - Pokemon Logo If you want another, let me know in the comments.

Print pauses at this point, the four corners are ready for magnet insertion

Ensure magnet “A” is inserted the opposite direction of magnet “B”

After the printer goes over the magnet holes two times, it should look like this or better