Nintendo Switch 2 Pro controller ? cube stand

Nintendo Switch 2 Pro Controller stand - Mario question mark cube controller stand

Remixed (I started designing it from scratch, but would have ended up exactly the same!) from a question mark cube by giuliomaffei90 to hold the new Switch 2 Pro controller.

This does fit the original Pro controller too, however there is a wiggle room either side, where it's a snugger fit for the Switch 2 controller (new controller is not as wide between the two grips as the original one).

Boost Me If you like this print, please consider a boost, it's a great way of supporting creators on here.  Printing

This will require an AMS to print. I printed this with the textured PEI plate and white and yellow filament. The print profile should cover everything else.