Compact Rod Holder for Boats, Coolers, and Wagons

A compact, individual fishing rod holder designed for mounting in narrow spaces where larger multi-rod racks will not fit. The slim profile makes it useful along boat interiors, beside storage compartments, or anywhere mounting space is limited.

It can also be adapted for use on:

- Coolers - Beach and fishing wagons - Kayak crates - Dock storage - Workshop or garage walls The rear includes two mounting holes with front-access through holes , making it easier to install and tighten the mounting hardware after the holder is positioned.

The open front slot allows rods to be inserted or removed without feeding the entire handle through the top. It works well for common spinning and casting rod handles, though fit may vary with oversized grips or large rod butts.

Printing Recommendations

- PETG, ASA, or another outdoor-rated filament is recommended - PLA is not recommended for extended exposure to heat and direct sunlight - Print upright - Supports should not normally be required - Additional walls or higher infill may be useful for rough water or heavy-duty use Mounting hardware is not included. Choose screws, bolts, washers, or inserts appropriate for the surface where the holder will be installed.