Two-Layer Gear Fidget Spinner - Print in Place

This is a print-in-place planetary gear fidget spinner with a unique dual-ring design . Unlike standard spinners, both the inner and outer rings spin independently , allowing for interesting effects like spinning the whole fidget and then stopping only the inner layer while the outer layer continues to spin.

The outermost ring features a textured knurled pattern , providing a better grip and a more tactile feel while spinning.

With a good spin, it can rotate for 15–20 seconds . For improved performance, applying a small amount of lubricant to the gears can help reduce friction and extend spin time.

🔧 Included Print Profiles:

- Single-Color Option - Multi-Color 4-Band Option (layered appearance) - 6 color changes - Flush volume: 0.65 (tested with no visible color bleeding — adjust as needed for your setup). 🖨️ Recommended Print Settings:

- Layer Height: 0.20 mm - Infill: 10% gyroid - Walls: 2 - Filament: Optimized for PLA Note: To achieve a print in place design, the gear tolerances are very fine , so it is strongly recommended not to alter the provided print profile settings (unless you know what you are doing). Changing certain parameters (like horizontal expansion or flow settings) may cause the slicer to accidentally fuse the gears together.

Feedback is always welcome. Happy printing!

Boost Me If you like this model, please consider boosting!