Cascading ORANGE! Decagon Fidget (NO AMS)

No AMS, EZ Mode 2.0, Variable Layer, Break-Off Connectors 2 Walls & 7.5% Infill. Stem is 0.1mm layer height.

Option to print all in 1 color or stem separately so you can make it a different color. 🖤🦊

YOU WILL NEED TO USE (minimal) force to push the slices to break thin, tiny, supporting connectors. This drastically improves stability during printing & reduces the chance of the model being knocked over.

AMS, EZ Mode 2.0, Variable Layer, Break-Off Connectors 2 Walls & 7.5% Infill. Stem is 0.1mm layer height.

YOU WILL NEED TO USE (minimal) force to push the slices to break thin, tiny, supporting connectors. This drastically improves stability during printing & reduces the chance of the model being knocked over.

(OLD) EZ Mode, Mouse Ears, Supports (for Stability)

(OLD) No AMS, Print Stem Separately, 0.2mm, 2 Ws, 7.5% Inf

(OLD) 1 Color, 0.2mm Layer, 2 Walls, 7.5% Infill

(OLD) AMS, 1 or 2-Colored Stem, 0.2mm, 2 Ws, 7.5% Inf I like to make the leafy part green & the tip brown. But I have a provided a plate with only 1 color, for the stem, if you prefer just green or brown.

(OLD) AMS, By Object, Print 1 or 2-Colored Stem Separately

Adaptive layer carefully tuned for top & bottom smoothness. Adaptive layer height carefully tuned for top and bottom smoothness.

many many substantial value adding adjustments also that result in low filament material waist and quick print time with reasonably good strength…

see the specifics below…

0.28mm layer, 1 walls, 0.6mm wall width, 0% infill, wall generator classic, detect over hang walls off, detect narrow internal solid infill off, ensure vertical shell thickness disabled, acceleration speed [ short travel , initial layer travel, initial layer, outer wall, top surface ] all turned up to 10000mms. max volumetric speed for PLA, and PETG both set to 30mm3/s, cooling for over hangs set to 100%, minimum fan for layers less than 4 seconds 100% and for the other layer times 100% and auxiliary part cooling fan 70%. volume modifiers added near the top to start sparse infill @ 15% for tricky over hangs, also height modifiers added to near the top to help with tricky over hangs around the outside of the top of the models that look like orange fruits. connectors removed, I don't think they are needed with clean standard textured PEI plate, also no brims, and first layer returned to standard 0.2mm 0.3mm probably was the problem originally but all good now.

note that filament flow, and cooling settings will likely revert to default and acceleration speed will also likely revert to default if you use a different bambu printer.

Disclaimer: some photos are edited simply to add color to give you ideas on selecting colors that make this look like an orange fruit.