1:64 Diecast EXPANDABLE Angled parking lot - AMS

Back at it again! Here's another model in my parking slot series, this one's angled and is also 10 slot. my AMS required parking lot that prints face down to get the “road” texture and is also fairly quick and cheap in material! You can chose to expand it length wise, it wont stack top and bottom as it wont line up

**PLEASE MAKE SURE YOUR PRINT BED IS CLEANED THOROUGHLY BEFORE STARTING THE PRINT. Do auto levelling to be sure.

**WAIT FOR MODEL TO COOL AND WATCH THE BED TEMP TILL ITS 40 DEGREES CELCIUS OR LESS! And then you can remove it

if you try to peel it off while warm its not gonna be flat and may warp.

dimensions is approx 230mm x 250mm making use of the whole bed as much as i can

Preferably this works best with Matte black PLA, as those seem to warp the least after it cools.

This is just the start of my dioramas, follow for more!

Boost Me Want more diorama stuff? Keep me going!

Straight angle parking lot 12 slot