5mm LED Neon Strip Holder & Cable Clip | LuminLux

A clean, no-glue way to mount 5 mm rubber (silicone neon-flex) LED strip. The holder grips the strip, keeps every run dead straight and tidies the cable, so your strip lighting finally looks installed rather than taped on.

WHY MAKERS PRINT THIS

• Holds 5 mm rubber / silicone LED strip firmly, with no adhesive on the strip itself

• Keeps long runs straight - no sagging or wavy lines across a desk or shelf

• Doubles as a cable clip for the tail end of the run

• 35 minute print, about 10 g of filament, no supports and no brim

WHERE IT WORKS

Desk and PC setups, behind a monitor or TV, under kitchen cabinets, along shelves and skirting boards, inside wardrobes, and in van and camper builds.

PRINT SETTINGS

• 0.4 mm nozzle, 0.20 mm layer height

• 2 wall loops, 15 % infill

• No supports, no brim required

• PLA is fine indoors. Use PETG or ASA if the run sits in direct sun or near a warm supply

FITTING TIPS

Space the holders every 100 to 150 mm on a straight run, and add one either side of a corner. Fix them down with a small dab of hot glue, a 3M square, or a countersunk screw into timber. Matte black disappears against most surfaces, while white or clear will pick up a little of the strip colour.

IF YOU PRINT ONE

Please post a photo as a Make and leave a rating - it takes thirty seconds and it is the single biggest thing that pushes a model in front of other makers. If the fit is tight or loose for your particular strip, say so in the comments and I will publish an adjusted size.