The Ultimate Adjustable Pixelsnap Charging Stand

The Ultimate Pixelsnap Charging Stand!

I made this because all other charging stands are not adjustable, are too bulky, too unstable, have cables hanging around loosely, cannot detach the phone gracefully - TLDR, they all suck, and mine does not. You can also find the MagSafe version here .

Some Highlights:

- Adjustable stances/modes! There are 3 degrees of adjustments in total, 80degrees, if you want an upright clock, 60degrees, which I use the most, and 20degrees, which is essentially laying flat on the table. - This is the 60degree mode: - - This is the 20degree mode: - - Easily detachable! I made grooves on the both sides so fingers can slide underneath the stand and detach phone a lot more easily than putting weights in the base or twisting it left and right - - Travel friendly: it can be folded into two flat pieces - - With built in cable management, so the cable doesn't just come out like a tail and hanging loosely, requiring other cable management solutions - Before You Print:

- I strongly printing the parts with the orientations AS-IS . If you lay down the base part, it might generate support within the slots, rendering them unsable. - Print and attach the optional base extender if you want to use the 20degree mode. It will make it much more stable - Support removal is a little bit tricky, so I strongly suggest using a needle nose plier. Boost Me Boosting is free and you get points too!