Purge Chute Cover - Dust protection P1P P1S X1C

Purge_Chute_Cover 0.2mm layer, 2 walls, 15% infill

LOGO addet, 0.2mm layer, 2 walls, 15% infill Druckereinstellungen:

- Postion horizontal gelegt, damit der Logodruck nicht so lange dauert - Logo hinzugefügt, welches natürlich in euren Farben angepasst werden kann Stützen sind bissel tricky zu entfernen, aber wenn man vorsichtig ist, geht das

Without Handle 0.2mm layer, 3 walls, 30% infill Print as it is without support, I used Bambu PETG-CF

- 0.2 Layer Height - 30% Gyroid infill - 3 Wall loops - Wall generator classic

0.16mm layer, 2 walls, 20% infill Printes in carbon fibre PLA and it came out absolutely gorgeous.  Well designed piece that fitted absolutely perfectly.  Good work Mr Designer.

0.08mm layer, 2 walls, 15% infill Based off of Molotovgod's print profile

Added a poop icon instead of the bambu logo

0.12mm layer, 2 walls, 15% infill, scaled +1% Profile I used ended up being too small for my gap, the bottom part kept tilting into the gap.  Measured everything and resized, turned out to be +1% to X-Y-Z.  It's now a gentle friction fit.  Now everything is flush with no gap.

0.2mm layer, 2 walls, 15% infill Here is a Profile for when you want to print the part using PETG with PLA as support Interface. AMS is recommended but not really required. The Print takes about 40 minutes and needs only 3 Filament changes.

The surface quality is very nice as shown in the Picture and fits perfectly into the Hole.