Coins Planter with Hidden Drip Tray

For 4 in. Container 0.2mm layer, 2 walls, 10% infill Suitable for a 3.5 in. to 4 in. diameter plant container. Inner diameter is 104mm.

For 5 in. Container 0.2mm layer, 2 walls, 10% infill Suitable for a 4.5 in. to 5 in. diameter plant container. Inner diameter is 130 mm.

0.2mm layer, 2 walls, 10% infill - A1 mini friendly A 4 In version for the A1 mini, with the seam in the back, 10% Gyroid infill, 4xtop&bottom shell, with decreased support angel, you will need a wire cutter to take it out but it will come out.

0.2mm layer, 2 walls, 10% infill Worked Well at 50% of the 4" size.  Used red Silk PLA and One plate.  Will work great for succulents

3 sizes, improved locking tray, optimised support All 3 sizes included (For 3in, 4in and 5inches) + the following optimisations:

- Added modifier to improve locking tray tolerance (too tight in the original model). - Optimised support for optimum quality/print time. - Infill combination to reduce filament cost and print time. - combined top and bottom on one plate where possible

5 inch, under 18 hours Forget gyroids.. standard settings are much quicker

Omit unnecessary stuff & get it done!

0.2mm layer, 3 walls, 4% infill & other tweaks 😉

4 inch, under 12 hours Forget gyroids.. standard settings are much quicker

Omit unnecessary stuff & get it done!

0.2mm layer, 3 walls, 4% infill & other tweaks 😉

4 inch planter, single plate with minor supports Prints planter and hidden drip tray on a single tray, perfect for overnight printing. Minor supports needed for locking tabs and groove