Grab & Go Skateboard Wall Mount

This is a grab and go, graphic side vertical wall mount for assembled boards.

It enables you to mount and unmount boards off the wall quickly and easily, giving you the ability to display your board graphic vertically when not in use without having to semi-permanently mount it to the wall.

Installation instructions: (For best results ensure you're mounting to a stud in the wall, countersink as necessary)

-Mount the Lower Mount first

-Place your board on the Lower Mount with the Upper Mount resting on the top of your board

-The Upper Mount should rest flat against the wall with light-moderate tension on the board

-Mark Upper Mount installation location and remove board

-Align Mounts against a parallel surface and mount Upper Mount

The board should fit snugly with a little room to move in the upper mount under light pressure. It doesn't have to be crazy snug to stay in place.

I have only printed in PETG so far and it's doing great. Most filament should work just fine, but YMMV.