3D-модель · MakerWorld

Muscular Santa Claus (Mrs. Claus Approved)

Сведения о модели

Площадка
MakerWorld
Цена
Бесплатно
Лицензия
PRIVATE-USE
Только для личного использования: печатать для себя, без продажи и распространения.
Форматы
3MFSTL
  • 1 083 Лайки
  • 1 302 Загрузки
  • 405 Напечатали
  • 2 044 В подборках
  • 110 Бусты
  • 91 Комментарии
  • 0 Просмотры

Автор:3DMakerSpace

Опубликована

Описание

Update : Through my ongoing efforts to give back to the community during the time of Christmas, I am making this model free to print and free to sell . Whether you gift it, decorate with it, or sell it at a holiday market, you’re helping spread the joy of making ! Happy Holidays!

He delivers gifts | He delivers gains | He keeps Mrs. Claus entertained

Santa’s been spending less time in the workshop… and a lot more time impressing Mrs. Claus at the North Pole Gym. She says he's sleighing harder than ever, and not just on Christmas Eve 😉

Boost Me No license required. No restrictions. Free to Sell! Just holiday joy, community sharing, and open creativity! 🎄✨ Boost if you liked this! Whether it's his 5.6" Showcase Flex Edition (Mrs. Claus’s favorite), the 3.2" Giftable Desk Buddy , or the 3.23" Ornament Edition that dangles just right on your tree—one thing’s for sure: Mrs. Claus can’t keep her mittens off him.

NOTE: Remove supports near his hat very carefully. If the pom-pom breaks off, just attach it with superglue or, even better, hold it gently with a tweezer/plier and heat it up very carefully using a lighter and stick it back to the red tip of the cap!

Руководства и профили печати

Профили печати и шаги

5.6" Tall (0.2mm layer, 2 walls, 2% infill)

3.2" Tall (0.2mm layer, 2 walls, 2% infill)

Tree Ornament (0.2mm layer, 2 walls, 2% infill)

Теги

Ещё по теме

Похожие модели

Названия используются только для указания источника результата. Polyzon не аффилирован с перечисленными площадками.