POLYZON
P2S / X2D Dust Cover Set
P2S / X2D Dust Cover Set — Фото 2 из 4
P2S / X2D Dust Cover Set — Фото 3 из 4
P2S / X2D Dust Cover Set — Фото 4 из 4
3D-модель · MakerWorld

P2S / X2D Dust Cover Set

Сведения о модели

Площадка
MakerWorld
Цена
Бесплатно
Лицензия
PRIVATE-USE
Только для личного использования: печатать для себя, без продажи и распространения.
Форматы
STEP
  • 4 358 Лайки
  • 13 324 Загрузки
  • 13 651 Напечатали
  • 19 564 В подборках
  • 235 Бусты
  • 1 858 Комментарии
  • 0 Просмотры

Автор:Kong 3D

Опубликована

Скачать на MakerWorld

Описание

Three-Piece Full Dust-Cover for P2S and X2D (Left + Center + Right)

This upgraded dust-cover set is designed specifically for the P2S to block debris, filament flakes, and dust from falling into the stepper motors and linear motion system. The design is split into three dedicated pieces - Left Cover , Center Cover , and Right Cover. So each section fits precisely around the machine’s geometry while still being easy to install.

Note:

- Each printer may have slightly different dimension due to manufacturing tolerance. - The X2D version print profile was added by Vinzent. Thank you. Key Features:

- Full Coverage Protection - Cover every hole in the back area of P2S chamber - Three-Piece Modular Design - Connected for smooth, continuous surfaces with no open cavities. - Easy Installation - Drops directly into place. No screws, drilling, or machine modification needed - Aesthetic Design - Pleasing to the eye - Easy to Print - No support needed

Руководства и профили печати

Профили печати и шаги

P2S Dust Cover Set

X2D Modified Center and Left Printed in Clear Polycarbonate PC. Should print well in ABS. The previous one shown in the pictures was white PETG HF, it melted in my X2D so I would not recommend that. I added 2 negative modifiers to the Center part to make room for the differences in the current X2D model.

X2D version with modified left cover Modified the left cover to fit with the heat element of the X2D. I'm recommending to print it in high temperature filament like ASA because of the higher chamber temperatures.

Adjusted middle piece For those who have issues fitting the middle piece, I've added a print profile with a few modifier so the middle piece will fit. I assume there are some slight differences between production batches of the P2S units hence why the original fits some but not the others. (Sorry my original print profile got deleted)

参数优化，加固模型，提高打印效率

Теги

p2sdust coverp2s upgradeprinter upgradep2s accessoriesback coverp2s back coverupgradehole coverp2s hole coverx2dx2d upgradex2d accessoryx2d back coverx2d hole cover
Ещё по теме

Похожие модели

Названия используются только для указания источника результата. Polyzon не аффилирован с перечисленными площадками.