Display Stand for Nerf Blasters (Elite Magazine)

This is a Nerf blaster display stand for blasters that use N-Strike magazines, or other compatible full length dart magazines (Dart Zone, Buzz Bee, X-Shot, etc).

There are two versions. One has the bottom “shoe” of the stand facing forward, and the other has it facing backwards. Choose the version that will work best for your blaster's weight balance!

There are also 2 extra versions without the over-insertion rim on the mag, which interferes with some blasters' tighter magwells.

Printing

I recommend you print all these parts at 5 walls, 20% infill.

If you have poor bed adhesion/warping, a brim might be necessary.

Supports are needed for the magazine catch notch.

Assembly:

Print the stand you like, and print the printed reinforcement bar.

Drip some glue into the hole on the bottom of the stand while holding it upside-down, then push in the bar all the way until it's flush with the bottom of the stand base.

Then place it somewhere where glue can drip safely while the glue dries.

There is a small built in support in the magazine catch notch of the stand. Break off the support with pliers, or cut it off with nippers.

Donations & Merch

If you like what I do, please consider supporting me!

I don't charge for my files, so any donations or merch purchases would be greatly appreciated!

- Patreon (Monthly donations) - Buy Me A Coffee (One-time donations) - RedBubble My merch shop, full of fun Nerf-y stickers and shirts!

Credit: This design is based on a Nerf magazine model originally made by CaptainSlug.