POOP CHUTE H2D / H2C / H2S

Poop Chute Bambu H2D / H2C / H2S

This model allows the evacuation of filament waste through a small slide that directs it towards your trash bin. Simple and effective.

The chute attaches to your H2D or H2S printer using the original screws. Filament waste goes through the slide and lands in your trash. Keeps your desk cleaner.

The chute has a side opening that allows access to any waste that might remain inside it. Indeed, it can happen that waste sticks to the chute (this happens to me with PLA but rarely,). To avoid this, you can print the object using a filament that tolerates heat better, such as PETG or PC.

If you want the same trash bin as in the photos, then go here :  LinkTrashBin

If you prefer a slightly different system, take a look at my other items:

Model 1

Model 2

🧩 Installation

Unscrew the original screws from your printer (see photo), position the chute, screw them back in.

Heads up:  One screw might be too short (see photo). Either use a longer screw, a magnet or just stick it with double-sided tape - works fine.

🧩 Compatible with Bambu Lab H2 Printer series : H2D, H2C, H2S

🧩 Print settings

✔  Material:  Prefer PETG or other filaments that are more heat-resistant than PLA, as there is less risk of the “poop” sticking to the chute. That said, I use PLA myself and I rarely have any “poop” sticking.

✔  Supports:  Yes (setting is already defined in the print profile)

Boost Me Hit the Boost button 🚀 it's free and helps me keep designing stuff for the Bambu community.

A note on print quality:  I test all my models before uploading. If your print doesn't turn out well, check your filament (old? wet?) and printer calibration first. Most issues come from these, not the model.