Tails the Fox Hueforge Sonic the Hedgehog Orange

Project: Tails.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 245x245mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

Filaments Used:  (* = Owned) #0f1011 * PLA eSun Black  Transmission Distance: 0.6 #91202b * PLA eSun Fire Engine Red  Transmission Distance: 5 #ff6a00 * PLA eSun Orange  Transmission Distance: 4 #ff9016    PLA BambuLab Basic Pumpkin Orange  Transmission Distance: 5.5 #e1e4e7 * PLA eSun Cool White  Transmission Distance: 2 This print uses 5 unique filaments

Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Fire Engine Red At layer #14 (1.2mm) swap to Orange At layer #17 (1.44mm) swap to Pumpkin Orange At layer #25 (2.08mm) swap to Cool White

Border Only Colors from here until the end. At layer #28 (2.32mm) swap to Orange for the rest.