Fluffy Tail Cute Flexi Cat Toy / Keychain

Updated with Stronger Joints (Key hole in head, ear, tail) For stronger joints, download this profile.

- Model size: 120mm - Material: PLA+ and PLA Matte

0.2mm layer, 2 walls, 15% infill

Same quality - Smaller File size with lesser polygon counts The file size of this profile is much smaller and the polygon count is less than 700K but the quality of the final print remains the same. Even PC with less specs can handle this.

Layers Carefully Tuned for Fine Detail & Critical Strengthen Layers Carefully Tuned for Fine Detail & Critical areas Strengthened

many substantial value adding adjustments also that result in low filament material waist and quick print time with reasonably good strength…

see the specifics below…

several volume modifiers placed in strategic areas to add strength just where it is needed.

0.16mm layer, 1 walls, 0.6mm wall width, 0% infill, wall generator arachne, detect over hang walls off, detect narrow internal solid infill off, ensure vertical shell thickness disabled, acceleration speed [ short travel , initial layer travel, initial layer, outer wall, top surface ] all turned up to 10000mms. max volumetric speed for PLA, and PETG both set to 30mm3/s, cooling for over hangs set to 100%, minimum fan for layers less than 4 seconds 100% and for the other layer times 100% and auxiliary part cooling fan 70%.

note that filament flow, and cooling settings will likely revert to default and acceleration speed will also likely revert to default if you use a different Bambu printer.

0.16mm layer, 1 walls, 0% infill

0.16mm layer, 1 wall, 0% infill, best quality for time rate I printed this cute😻 model on my A1 mini.

- It has 0 supports, and 0% infill → 0 waste - No AMS needed. - Print in place. I think, this is the best quality for time rate, with only 54 minutes of printing time.

Single color If you enjoy this print, please consider leaving a 5-star rating! ⭐⭐⭐⭐⭐

SCALED to 95% optimised material usage 0.2mm layer 7% infill What I changed

- Scaled to 95% - Reduced purge amount - Infill: 7% - Top layers: 4

Verstärkte Verbindung, Loch im Ohr, 0.16mm, 4 W, 15% infill Ich habe beim ändern der Farben bei der linken Katze die Pfoten andersrum gefärbt. passt aber trotzdem ganz gut. Bei bedarf kann man aber Katze links oder rechts einfach kopieren.

Es ist nur das Modell mit dem Loch im Ohr. Ich habe Regenbogen Silk PLA verwendet

0.16 Layerhöhe

4 Wände

15% Gyroid Füllung

Arachne

verringerte Geschwindigkeit

细节参数优化版