Phillips Hue Dimmer V2 Stand for Double and Single

Similar to my stand for the V1 version of the Phillips Hue Dimmer, I needed a hue dimmer stand for the V2 dimmer as I had a few of them as well. Same as for the V1 version dimmers, this also fits snugly, there is no reason for magnets to hold it in place. It however does not sit flush with the stand as it does not have a border as the V1 dimmers do, so to avoid the buttons getting stuck, I only have the depth until the body is in the stand. It might be a bit of a push to get it in but it fits. There is a hole at the back to push it back out if required, I printed in both PLA and PETG but the ones pictured are in PETG White and they seem to match better to the buttons.

Have a single and double (just two singles mashed together)

The model is optimised for very little filament, no supports are required.

Boost Me Let me know if this works well for you.