Drawer Handle – 40mm

Boost Me If you like my work, support me with a Boost, thank you all very much A clean and minimal drawer handle, designed to be printed without supports. Simple geometry, solid result.

Perfect for furniture, cabinets, and small drawers. Print it in any color to match your setup.

📐 Specs

- Width: ~40mm - Mounting: 2x screws (holes included) - No supports required - No brim needed 🖨️ Print Settings

- Material: PLA - Layer height: 0.2mm - Infill: 25% - Walls: 6 perimeters - Orientation: flat side down ⚠️ Note: Bambu Studio may suggest supports — ignore it. The model prints perfectly without them.

🔩 Assembly Insert screws through the two mounting holes directly into the furniture surface. No hardware included.