2x4 Work Bench or Shelf Leg Protectors "L" Shaped

Boost Me If you find this useful I'd appreciate a boost! Protect the end of your 2x4 work bench or shelf legs to prevents the board from absorbing any moisture from the ground or splintering if you slide it over the ground.  This is for two boards secured together at a 90 degree angle making an “L” shape which is often used to make very sturdy work bench or shelf legs.

Note that 2x4's are not a precision milled board and can vary dimensionally.  I iterated a few times to end up with a nice friction fit, but a different lot of boards could make the fit loose or tighter to the point where you may need to slightly scale the model.  In most cases scaling by 1% bigger or smaller will be sufficient.  Also, you need to make sure your boards are flush on the one end and nailed together at a true 90 degrees.  Again, scaling bigger can compensate for imperfections.

This model is for a single stand alone 2x4 leg version: 2x4 Work Bench or Shelf Leg Protectors - Free 3D Print Model - MakerWorld

Into wood working, check out some of my other popular models:

90 degree corner sander: 90 degree corner sanding block - Free 3D Print Model - MakerWorld

Blade protector: 10" saw blade protector - Free 3D Print Model - MakerWorld

Clamp support block: Parallel clamp support block - Free 3D Print Model - MakerWorld

Drill bit depth gauge: Drill Bit Depth Stop Gauge - Free 3D Print Model - MakerWorld

Ratchet strap saver: 1" Ratchet strap saver corner - Free 3D Print Model - MakerWorld

Drill guide: Drill guide for edges, angles, and rounds - Free 3D Print Model - MakerWorld

Gap measurement: Gap Measurement Tool - Free 3D Print Model - MakerWorld

Glue spatula: 2 sided glue spatula - Free 3D Print Model - MakerWorld

Click my name to check out my other wood working tools and give me a follow so you don't miss out on future models!