Charms Series 07 – Farm Animals

This time the Charm System goes a little more countryside.

Series 07 is a small farm-inspired set with animals that feel simple, playful, and easy to mix into the rest of the collection. You’ll find a sheep, chicken, cow, pig, and horse — all made to fit the same plug system as the rest of my charms.

This series was actually made from a request, so I really hope the person who asked for it likes how it turned out 😊

And just to be honest: the photos did not fully do these ones justice. I had a harder time photographing this set without the setup I usually use, and some of the charms shown here were also printed on a textured plate instead of a smooth one. In real life, they look cleaner and more defined than the pictures suggest.

Like the rest of the system, these charms are made to be printed, swapped, and collected. Use them with the compatible hair models, mix them with other series, or build a full themed set.

Important Notes / Tips

Printing time is around 20–45 minutes per charm , depending on the design.

If you want the cleanest details, especially on the smaller features, I recommend a 0.2 mm nozzle . For the best results, aim for very fine detail limits (around 0.08 mm minimum feature , depending on your slicer and printer). Smaller details can disappear quickly with a 0.4 mm nozzle.

That said, I printed these using a 0.4 mm nozzle with the same settings included in the file, to show the most common result since not everyone has a 0.2 mm nozzle.

I only use Bambu Lab filament .

Every charm is based on a 2.5 × 2.5 cm base plate in Fusion. Some designs extend slightly beyond 2.5 cm, while most are slightly smaller.

Charm System Collection

Charm System Collection: Charms collection

Compatible Models

These charms are compatible with my charm-based hair models, including:

Hair Clips Hair Clamps Hair Sticks

Extra

I also made a simple Charm Tray where you can store up to 20 charms and personalize it with your own name.

And if you want to make your own, I included my first OpenSCAD file ever — a simple parametric name generator that creates a matching charm plug. If you find any bugs in it, please tell me 😊

If you have questions, improvement ideas, or want a specific charm theme next, feel free to reach out. I’d love to keep expanding this system if people enjoy it.