HY300 / HY300A Projector Lens Cap – Snap-On

HY300 / HY300A Projector Lens Cap (Snug Fit, Lightweight, Fast Print)

Lens cap designed specifically for the HY300 and HY300A mini projectors. It protects the lens from dust, scratches, and accidental contact when the projector is not in use.

The cap stays securely in place — it won’t slide around or fall off during handling or transport, yet it’s still easy to remove when needed.

The bottom surface shows a subtle honeycomb pattern , which comes directly from printing on a BIQU Honeycomb build plate (Botland).

Key Features:

- Compatible with HY300 / HY300A projectors - Snug fit — secure, no slipping or falling off - Very lightweight — uses less than 18g of filament - Fast and easy print - No supports required Print Notes:

- Tested with PLA nozzle 0.8 mm - Pattern on the bottom depends on your build plate surface If you like the design, a like or boost means a lot ❤️

Happy printing and enjoy your movie nights 🎬🍿