The Viking Custom Pen Holder !

The Viking Pen Holder !

Next up in the Pen Holder Series - The Viking! A couple of annoying supports to remove, but again, just take your time with the snips like with the other models and you'll be done in no time! Particularly around the axe and the beard, need to be very careful, or be ready to take out your super glue!. I recommed Matte PLA or Slilk PLA ( something with no too good of a layer adhesion) as these tend to release the supports REALLY easily. Like with the other models, there is some scarring underneath at the support areas that can be cleaned up with a quick pass of a butane torch/heat source.