Sad Darth Vader sitting on a ledge figurine!

0.16mm layer, 2 walls, 15% infill

Gürtel und Knöpfe gefärbt - geteilt für einfacheren Druck Habe die Knöpfe und den Gürtel eingefärbt

Geschnitten und auf Platte so plaziert, dass der Druck einfach ist.

Gedruckt mit:

Jayo PLA+ Schwarz

Sunlu PLA Rot

Sunlu PLA Mint Grün

Sunlu PLA SIlk SIlber

0.08mm Layer, 3 Walls, 10% Infill, Gyroid Auf einem P1S gedruckt mit 0,4 Nozzle

Parameter: 0,08mm Layer

3 Walls

10% Infill (Gyroid)

Stützstrucktur aktiviert

Außenwände auf 100 mm/s

模型优化，提高打印效率

Adaptive Layer Height Carefully Tuned for Smooth Dome & Arms Adaptive Layer Height Carefully Tuned for Smooth Dome & Arms

many many substantial value adding adjustments also that result in low filament material waist and quick print time with reasonably good strength…

see the specifics below…

0.16mm layer, 1 walls, 1mm wall width, 0% infill, wall generator arachne, detect over hang walls off, detect narrow internal solid infill off, X-Y Contour compensation 0.5mm, acceleration speed [ short travel , initial layer travel, initial layer, outer wall, top surface ] all turned up to 10000mms. max volumetric speed for PLA, and PETG both set to 30mm3/s, cooling for over hangs set to 100%, minimum fan for layers less than 4 seconds 100% and for the other layer times 100% and auxiliary part cooling fan 70%.

note that filament flow, and cooling settings will likely revert to default and acceleration speed will also likely revert to default if you use a different Bambu printer.

Also in case you were looking really closely only the middle picture is of the printed model using this print profile, there are no holes after printing with PETG.