Wall/Cupboard-mounted Bin Bag/Roll Dispenser

Compact wall-mounted dispenser designed to hold and dispense bin bags from a roll. The front cut-out allows easy access and controlled pulling of bags, while keeping the roll neatly contained.

The design supports two mounting methods:

- Screw mounting via four rear slots for a secure, permanent install - Adhesive mounting using double-sided tape for non-destructive placement Optimized for standard bin bag rolls and suitable for kitchens, utility rooms, or inside cabinets.

Key Features

- Clean, minimal enclosure with front access slot - Supports multiple mounting options - Keeps rolls tidy and prevents unraveling - Easy reload by dropping in a new roll - Compact footprint for tight spaces Print Settings (Recommended)

- Material: PLA (tested with PLA Basic) - Layer height: 0.2 mm - Walls: 3–4 perimeters - Infill: 15–20% (grid or gyroid) - Supports: Not required - Orientation: Print upright (as shown) Dimensions / Fit

- Designed for standard bin bag rolls (adjust scale if needed) - Ensure roll width and diameter match your local bag type Mounting Notes

- For screws: use countersunk screws sized to your slots - For adhesive: clean surface thoroughly before applying tape Potential Improvements (optional section)

- Add drainage holes if used in damp environments - Scale width for larger/heavier-duty bag rolls - Consider PETG if mounting in warmer areas Remixes Welcome - Please share improvements.