Padel Court Camera Phone Holder (Modular Design)

Designed this padel phone mount to easily record matches without having to carry around a bulky tripod. It slips directly over the net tape and securely holds your phone in either horizontal or vertical orientation so you can frame the court exactly how you want for swing analysis or match recording. I also added a cutout hole at the bottom of the holder allowing you to plug in a charging cable to a power bank if you are recording long tournament sessions and need the extra battery life.

To make this practical for throwing into a crowded sports bag, the design is broken down into three separate attachable pieces connected by a strong dovetail joint system. This modular approach means the mount lays flat in your bag preventing awkward stress on the plastic that usually leads to snapped parts. If a stray ball does happen to hit the mount and break a piece, you only need to reprint that specific broken part instead of wasting filament on an entirely new assembly.

Recommended Print Settings

Material: PETG, ASA, or ABS is highly recommended if you play on outdoor courts in the sun, but PLA works perfectly fine for indoor air-conditioned courts.

- Wall Loops / Perimeters: 3 or 4 walls to ensure the dovetail joints and net hook are rigid and strong. - Infill: 15% to 25% Gyroid or Cubic for good impact resistance against ball strikes. - Layer Height: 0.2mm provides a good balance of print speed and dimensional accuracy for the joints. - Supports: Tree supports are recommended only for the overhanging sections of the dovetail slots depending on how you orient the parts on the build plate. - Brim: Not required unless you have bed adhesion issues with the taller vertical pieces.