Mobula7 1S – 450mAh & 520mAh Battery Holder

Keep your 1S packs locked down during aggressive freestyle flights and hard crashes. This ultra-lightweight, friction-fit battery holder replaces loose rubber bands and provides a perfect, secure fit.

🧪 Tested & Verified Compatibility

- CNHL 450mAh 1S - Boslipo 520mAh 1S 🖨️ Recommended Print Settings

- Material: Bambu Lab TPU 95A HF (Highly recommended for a perfect, tight fit) - Layer Height: 0.2mm - Infill: 15% - Supports: Automatic ⚠️ Installation Guide (Read Before Installing!)

To avoid snapping or stressing your micro whoop frame, do not try to force it straight in. Follow these steps:

- Remove the stock battery arrangement. - Slide one side of the TPU holder into the frame bracket first. - Use tweezers or the tip of a small screwdriver to gently pry and push the other  Boost Me Loved this print? Support the design with a Boost!

If this holder saves your batteries from ejecting on a hard gate and keeps you in the air, please consider tossing a Boost my way!

Designing, prototyping, and testing with different battery sizes takes time and filament. Your Boosts directly help fund the next handy FPV upgrade on my workbench.

Don't forget to Rate ⭐⭐⭐⭐⭐ and upload a photo of your print—I’d love to see your micro whoop setups! Safe flying! 🛸 - side under the frame until it clicks into place. If this saves your batteries from ejecting, please leave a ⭐⭐⭐⭐⭐ review and post your make!