Wild Kratts Creature Power Vest

Summary

My kids are big Wild Kratts fans. I remixed a vest before, but was never really happy with it. It was too hard for my kids to get the disks out once they were in.

I added an angle to the back of the disk area to raise it up a bit and then made sure there was room on front and back. I can get my fingers in to pull out the disk, so little hands should have no trouble at all.

My test print fit perfectly, but I will probably end up gluing it. There is a bit of excess gap at the bottom of the disk, so it may rattle if they run around with it.

I ordered a set of 1" straps from Amazon to buckle these on. I may revise it once they've been field tested.

I've previously posted disks, disk holders and creature pods. The disks are included with the disk holders. There's about 40 animal power disks at the moment. I upload them anytime they request a new one.

Creature Power Disk Holders

https://makerworld.com/en/models/2810398-creature-power-disk-holders#profileId-3229707

Wild Kratts Creature Pod

https://makerworld.com/en/models/2813193-wild-kratts-creature-pod#profileId-3273387