Hornet 750

Following the success of the 50cm version ( https://makerworld.com/it/models/2488124-scarlett-500#profileId-2733776 ), this beast is scaled up by 150% , reaching a total length of approximately 750mm .

Please note: This is the HULL ONLY. This high-performance hull design is proven to work flawlessly in the water. It features perfectly proportioned internal guides for the same 4mm carbon rods as the smaller model, but contains no pre-designed internal mounts (motor, servo, etc.). All mechanical hardware must be purchased and adapted separately.

Printing Advice:

- Material: PETG is highly recommended. - Waterproofing: Coat the hull with epoxy resin. Follow the same printing and post-processing guidelines as the 50cm model. - The minimum required build plate size to print this model is 256x256 mm (Bambu Lab A1 size or equivalent). Please note that it will not fit on smaller beds like the A1 Mini. Recommended Setup:

- Motor: 3660 - 3670 Brushless - ESC: 100A Minimum - Battery: 3S or 4S LiPo Boost Me If you love this 750mm beast and want to support more free RC designs, please drop a Boost! Thank you! 🙏