Minimal MagSafe & Apple Watch Charging Stand

Minimal MagSafe & Apple Watch Charging Stand

A clean and compact 3D-printed charging stand designed for a MagSafe charger and an Apple Watch charger.

The Apple Watch charger is positioned below and behind the phone while remaining mounted in front of the main support. When a phone is attached, it hides most of the Apple Watch charger from the front, creating a clean and minimalist appearance.

The phone can be used in both portrait and landscape orientation, making the stand suitable for everyday charging and iPhone StandBy mode.

Both charging cables are routed along the rear of the stand and held in place by integrated cable clips.

Perfect for a desk, bedside table or office setup.

Features

- Holds a MagSafe charger - Holds an Apple Watch charger - Supports portrait and landscape phone orientation - Suitable for iPhone StandBy mode - Phone hides most of the Apple Watch charger from the front - Integrated rear cable management clips - Compact footprint - Clean minimalist design - No screws or additional hardware required - Simple assembly - Designed and tested for 3D printing Charger Compatibility

The model was designed around the following charger dimensions:

- MagSafe charger: approximately 56 mm diameter and 4.8 mm thick - Apple Watch charger: approximately 27.7 mm diameter and 6 mm thick Please measure your chargers before printing. Third-party and newer charger versions may have different dimensions.

Print Profiles

Two tested print profiles are included:

0.16 mm profile

- Layer height: 0.16 mm - Walls: 4 - Infill: 20% - Higher surface quality - Longer print time 0.20 mm profile

- Layer height: 0.20 mm - Walls: 4 - Infill: 20% - Faster printing - Good everyday quality Recommended materials:

- PLA - PETG Supports are recommended for the upper MagSafe arm and other unsupported overhangs. Use at least four walls for good strength around the main arm and charger holders.

Assembly

- Thread the Apple Watch charger cable through the hole in the stand before installing the charger. - Pull the cable through until the Apple Watch charger reaches the smaller holder. - Press the Apple Watch charger into the smaller holder. - Press the MagSafe charger into the large front holder. - Route both cables down the rear of the stand. - Press the cables gently into the integrated rear cable clips. - Attach your phone to the MagSafe charger in portrait or landscape orientation. Important: The Apple Watch charging cable must be threaded through the stand before the charger is pressed into its holder. The MagSafe cable is routed directly along the back.

Notes

This download includes the 3D-printed stand only. Chargers, cables, phone and Apple Watch are not included.

Fit may vary slightly depending on your printer calibration, filament and charger version. If the fit is too tight, check your flow calibration before scaling the model.

Please share photos of your print, and feel free to leave feedback or suggestions for future improvements.

If you like the model and find it useful, a Boost is greatly appreciated and helps me create more designs.