Бесплатно 
Kia Niro 17-22 Car Speaker Adapter
Printables
3D-модель · MakerWorld
KIA Sportage QL door speaker replacement adapter
Сведения о модели
- Площадка
MakerWorld
- Цена
- Бесплатно
- Лицензия
- уточняйте на площадке
- Условия задаёт автор — проверьте их на странице модели, прежде чем печатать на продажу.
- Форматы
- 3MFSTL
- 6 Лайки
- 11 Загрузки
- 4 Напечатали
- 26 В подборках
- 0 Бусты
- 0 Комментарии
- 0 Просмотры
Описание
This adapter fits the KIA Sportage QL (at least models from 2016 to 2018) and is designed to replace the original speakers, which often fail due to humidity. I used Pioneer TS-G1720F speakers because they are affordable and should hold up better in damp environments. However, any 6.5-inch 4-ohm speaker should work perfectly fine.
Installation notes:
- I added some foam insulation between the adapter and the car door to minimize vibrations. - The dark grey foam ring on top is salvaged from the original speaker and secured in place with hot glue. - The notch in this 3D-printed adapter fits the original wire connector perfectly. Simply cut the wires from the original speaker, remove the connector, and slide it into your newly printed adapter. I first remembered to take a picture after actually putting the dorr panel back in place… sorry about that
Boost Me Please leave a like and and boost if you like this model
Руководства и профили печати
Профили печати и шаги
PETG - 0.2mm layer, 6 walls, 25% infill Please do not use PLA as it will not stand up to the heat on a sunny day
Похожие модели
Названия используются только для указания источника результата. Polyzon не аффилирован с перечисленными площадками.