Snapmaker U1 PopCap Hydrometer

Here is a quick and easy add to the Snapmaker U1 PopCap by adding a hydometer with the factory holes on the front corner of the popcap and the meter sits flush with the front panel by being slightly recessed into the bracket. I printed this with support to allow the hydrometer hole to be supported but the rest in my testing did not need supports in my experience. The holes for the screws are slightly undersized so the actual screw will thread in and be very sturdy to make it even simpler.

Bill of Materials:

2 - 3MMx8MM screws (preferably low profile head allen key)

1 - Hydrometer  ( https://a.co/d/09YGGBwS ) VERY IMPORTANT to use these hydrometers as the hole is designed for them as i found the cheaper ones have a different pattern to the clips

- Sunlu PETG Matte high speed white was used and found this to be a very close comparison to the U1 casing.