Gopro/Action Camera Hot shoe Mount

This gopro to hotshoe/coldshoe mount is useful for attaching any kind of action camera or mounting accessory to your camera or other item using a shoe mount. It is often used to attach a GoPro to your DSLR/Mirrorless/Cinema camera as backup footage or to use as a photography vlog/tutorial setup.

Weight: <6g

Print time 20-40 minutes (depending on layer height) (I recommend using the ‘High Quality’ print profile if you have the time)

If using a higher layer hight eg: 0.24mm I recommend using supports to increase dimensional accuracy, this is not compulsory.

Supports only add <0.5g of filament to the print.

80% Triangular Infill is used for strength.

Some people might find the standard fit hot shoe mount to be slightly too loose so I have included a “Tighter Fit” print profile.

Requires M5 x 0.8 Hex Nut - very cheap to buy from local hardware store, or you could take the nut out of a standard Gopro mount.

Boost Me It helps me to keep creating useful designs like this one!