UppaBaby Cruz Big Bottle Cupholder

Nalgene Cup Holder for UPPAbaby Stroller

A cup holder sized for Nalgene wide-mouth bottles that mounts to an UPPAbaby stroller. Most stroller cup holders are designed around skinny disposable bottles or coffee cups and a 32oz Nalgene either won't fit or sits so top-heavy it launches on the first curb drop — this one is sized for the real thing so you can actually bring enough water for a long walk.

Fit

Designed around the standard 32oz wide-mouth Nalgene. It will also hold other bottles of similar diameter, but the fit is intentionally snug for the Nalgene so it doesn't rattle. Verify your stroller's mounting point matches before printing — I designed and tested this on an UPPAbaby Cruz.

Print settings

- Print with the floor of the cup on the top; supports are easier to remove from the cupholder floor than the clip mounting area. - Material: PETG (printed in Bambu Lab PETG). Recommended over PLA - Supports: Yes — tree supports are needed in the middle section. Tree supports pop off PETG cleanly, I used Bambu support for PETG to make the interface - No other special settings needed; standard layer height and walls are fine. Bump to 4 walls if you want extra durability, since a full Nalgene is over 2 lbs.