Windswept Maple Leaf - LED Tealight Holder

Windswept Maple Glow is a maple leaf tealight holder inspired by a single leaf twisting through the autumn wind. The curled shape wraps around the light and creates a warm glow with dramatic shadows around it. Perfect for a shelf, coffee table, entryway or a windowsill.

*Only intended for LED lights.

Model printed with: Bambu PLA Matte - Terracotta (11203)

Filament recommendations:

Ziro - Afterglow : https://www.amazon.com/gp/product/B0D78F2FYT/ref=ox_sc_act_title_10?th=1

Ziro - Maple Forest : https://www.amazon.com/gp/product/B0CZ43KVF7/ref=ox_sc_act_title_10?th=1

Printing

- Use a clean print plate with some glue (unless you are using a super tack plate) - Use dried out filament - ( Different filament types impact the print differently, please adjust your print speed settings accordingly.) Support Removal:

- Let the model cool down before removing the supports. - Use pliers when removing the supports. - Start with  breaking (crushing) the support in the middle. - Work gently and remove the supports in pieces. No specific order, it should come off pretty easy. Light sanding and gentle, controlled heat may be needed to clean up areas where the supports were attached. I used a handheld mini torch, but apply heat carefully to avoid warping or damaging the print.

If you like this design,  please leave a rating, a comment or a boost .

Boost Me Give this leaf a little extra gust of wind with a Boost 🍂

No worries if you can't boost, a rating or a comment is very much appreciated as well! 💛