Spider Web Coaster - No AMS

Want some Halloween decor for the table without going over the top?

Here's a line art drawing coaster of a spider web! It serves as a nice table piece thats both functional and does its aesthetic job. I wanted to fill the holes of the web without just encapsulating the whole web design in a circle, or just having a filament change in the middle of the model making a lazy colour line. I decided to make this two pieces, allowing people without AMS or multicolour units to print this and assemble it no problem. Prints in two plates.

Assembly - very easy

It prints in these two pieces, the insert and web

I set the web to print with a brim (just for extra stability), so you may need to remove it. You are left with these two pieces, and its as simple as slotting the web into the white base. The web is not symmetrical, so its just a matter of rotating it till it lines up with the base.

This fit is just pressure fitted, with approximately a 0.15-0.20 difference. Its not meant to be a snug fit in case of assembly to clean, but it can be easily permanently assembled with a drop of glue. But thats it! Only recommendation I have is to use PETG for the heat resistance of hot drinks or hot water. Enjoy!