Arch Katana from Roblox Rivals

This model is my attempt at modeling the Arch Katana weapon skin from Roblox Rivals.

The katana once fully assembled is 50cm in length, so about 20 inches.

All colored parts print independently so no AMS is required. You just need a bit of CA glue for assembly.

Print all part then for assembly:

- Print all parts and remove all supports, including the holes for the lining pins (I use a small tip flathead screwdriver for this) - Press fit the two blade parts together using the provided lining pins to ensure a perfect fit. Add a bit of CA glue if needed. - Then fit the two sides of each of the wing guard together, also using lining pins. - Then you can fit the blade, the wing guards and the handle into the main guard body. Use CA glue to secure everyting in place - Then glue the gems in the guard and the diamonds in the handle as well as the pommel Boost Me Thank you very much if you are considering boosting this model :)